Table of Contents
Advertisement
Scorpion 40 Installation Manual, Rev. A
Mounting the drive in a 5.25-inch drive bay
If you are mounting the drive in a 5.25-inch drive bay, you
must use a drive with mounting brackets. As shown in Figure
4 below, the 5.25-inch drive brackets have four screw holes
on the bottom and six on each side.
Figure 4
Mounting holes for internal Scorpion 40 in 5.25-inch
configuration (with mounting brackets)
41.3 mm
(1.63 in)
31.5 mm (1.24 in)
21.8 mm (0.86 in)
9.9 mm (0.39 in)
16-M3
41.2 mm
(1.62 in)
Side View
Note: Tolerance for all dimensions is 0.25mm (0.01 in)
79.4 mm
174.6 mm
(3.13 in)
(6.87 in)
47.6 mm
(1.87 in)
146 mm
(5.75 in)
139.7 mm (5.50 in)
149.1 mm (5.87 in)
Bottom View
11
Advertisement
Table of Contents
