Epson ET-5170 Series User Manual page 97

Faxing
>
Menu Options for Faxing
Sharpness:
Enhances or defocuses the outline of the image. + enhances the sharpness, and - defocuses the
sharpness.
ADF Continuous Scan:
Sending faxes by placing originals one by one, or by placing originals by size, you can send
them as one document at their original sizes. See the related information below on this topic.
Fax Send Settings:
Direct Send:
Sends a monochrome fax while scanning the originals. Since scanned originals are not stored
temporarily in the printer's memory even when sending a large volume of pages, you can avoid
printer errors due to a lack of memory. Note that sending using this feature takes longer than
not using this feature. See the related information below on this topic.
You cannot use this feature when sending a fax to multiple recipients.
Send Fax Later:
Sends a fax at a time you specified. Only a monochrome fax is available when using this
option. See the related information below on this topic.
Add Sender Information:
❏ Add Sender Information
Select the position where you want to include the header information (sender name and fax
number) in the outgoing fax, or not to include the information.
- Off: Sends a fax with no header information.
- Outside of Image: Sends a fax with header information in the top white margin of the fax.
This keeps the header from overlapping with the scanned image, however, the fax received
by the recipient may be printed across two sheets depending on the size of the originals.
- Inside of Image: Sends a fax with header information approximately 7 mm lower than the
top of the scanned image. The header may overlap with the image, however, the fax received
by the recipient will not be split into two documents.
❏ Fax Header
Select the header for the recipient. To use this feature, you should register multiple headers
in advance.
❏ Additional Information
Select the information you want to add. You can select one from Your Phone Number and
Destination List.
Transmission Report:
Prints a transmission report after you send the fax.
Print on Error prints a report only when an error occurs.
When Attach Fax image to report has been set in Settings > General Settings > Fax Settings
> Report Settings, faxes with errors are also printed with the report.
Clear All Settings:
Restores all settings in Scan Settings and Fax Send Settings to their defaults.
>
Fax Settings
97