Enterasys RoamAbout R2 Installation Manual page 45

10. Connect the 10BaseT/100BaseT
Ethernet network cable.
— If you are using the remote power
feature, label the end of the cable to
the RoamAbout R2 with:
CAUTION: Ethernet cable
contains power. Do not use for
other devices.
— If you are not using remote power,
install the power module/redundant
power module, if used; refer to
Power Supply Installation on
page 2-7.
11. Connect the power module into an AC
outlet.
12. Verify that the power is on by observing
that some of the RoamAbout R2 LEDs
are flashing or lit.
Surface Wallmount Installation
Power
Connector
Ethernet
Cable
Connector
R2_31
3-15