3Com 3108 Code Manual page 14

14 C 1: F
HAPTER EATURE
Table 3 NBX Feature Codes (continued)
Features
Caller ID Restriction
(CLIR — Next Call)
Restrict the NBX system from
sending out your Caller ID
information for only this call.
Do Not Disturb — On/Off
Send all incoming calls directly to
the call coverage point that you
specified in the NBX NetSet utility
Call Forward > Call Forward or
Override.
Forward All Calls to Voice
Mail — On/Off
Send all incoming calls to your
voice mailbox (or to wherever you
have specified as your call
coverage point) after one ring on
your telephone.
Password — Set Initially
Use this code sequence to set
your NBX NetSet utility password
for the first time.
C
ODES
Using Codes
Press *
+ 890
+ *
+ Dial outside party's
number
+ Send
Press *
+ 446
+ Send
Persists until you turn
off the feature by
repeating the
sequence.
Press *
+ 440
+ Send
Persists until you turn
off the feature by
repeating the
sequence.
Press *
+ 434
+ *
+ new password
+ *
+ repeat your new
password
+ Send
Notes
To use this feature you must have CLIR Features
enabled for your Class of Service (CoS) group. To check
if you have CLIR Features enabled, log in to the NBX
NetSet utility and go to My Calling Privileges > Call
Permissions.
To view the current setting, log in to the NBX NetSet
utility and go to My Calling Privileges > Feature
Settings.
To view the current setting, log in to the NBX NetSet
utility and go to My Calling Privileges > Feature
Settings.
You can use this procedure only if you or your
administrator have not previously changed or reset this
password from its default value of 1234. If your
password has already been changed or reset, you must
use the Password — Change procedure to change
the password.
When typing your password:
Use only 4- to 10-digit numbers
Do not use letters, *, or # as part of your password.
After you set your NBX NetSet password, you must set
the SIP authentication password in your SIP telephone
to match the new NBX NetSet password.