Sony XAV-701BT Service Manual page 5

NOTE THE MAIN BOARD OR SYSTEM CONTROLLER
(IC502) REPLACING
When the complete MAIN board or system controller (IC502) is
replaced, the destination setting is necessary.
1. Preparing the Destination Setting
Be sure to solder the SL501 on the MAIN board before doing the
destination setting.
– MAIN Board (Component Side) –
SL501
2. Destination Setting
Set destination according to the procedure below.
2-1. Setting the Destination Code
1. In the state of source off (Home screen is displayed), enter the
test mode by pressing the buttons in order of the [4] t [5] t
[6] on the remote commander (press only the [6] button for
two seconds).
2. The following screen is displayed and the destination setting
mode becomes effective.
(Displayed characters/values in the following fi gure are ex-
ample)
Note: Refer to following "2-2. Entering the Destination Code" for opera-
tion method.
<DESTINATION SETTING>
0 0 0
EUR 000000 MECHA(EUR) 000006
UC 000001 FT(JPN)
E17(P3E) 000002 BR(N4E)
E(N4E) 000003 EA
RU2(P5EUR) 000004 EJ(EUR)
3. The resetting operation is executed by pressing the [SOURCE/
OFF] button for 1 second after the setting ends, and the unit
returns to the normal condition.
2-2. Entering the Destination Code
Note: Input of the destination code cannot be performed by the keys of
main unit. Be sure to input the destination code by remote com-
mander.
• Method of operation by remote commander
IC502
0 0 2
000007
000008
00000A
00000B
1. Press the [ ] or [ ] button, and select the alphanumeric char-
acter of "0 to F".
2. The digit advances by pressing the [
The digit returns by pressing the [
3. The setting is completed by pressing the [ENTER] button, and
the initialization operation is done.
2-3. Destination Code
Model Destination
XAV-701BT E (NTSC) model
XAV-701BT/741 E (PAL) model
XAV-701BT South African model
XAV-701BT/741 Russian model
3. Confi rmation After Destination Setting
Execute the following operation after completing the destination
setting, and confi rm a correct destination was set.
Destination setting checking method:
1. In the state of source off (Home screen is displayed), enter the
test mode by pressing the buttons in order of the [4] t [5] t
[0] on the remote commander (press only the [0] button for two
seconds).
2. The following screen is displayed and confi rm that item of the
destination has been rewritten correctly.
(Displayed characters/values in the following fi gure are ex-
ample)
<TEST MODE>
1. Audio FACTORY MODE
2. Audio DEBUG MODE
4. Visual FACTORY MODE
Temperature : 0xf9
5. ENGINEER MODE
6. DESTINATION MODE
AVC Ext NAVI
8. MECHA MODE
9. NAVI/RGB-OUT MODE
Master: SR04
Mecha:
BT Module: 3010
Display: SA08
3. The resetting operation is executed by pressing the [SOURCE/
OFF] button for 1 second after the confi rming ends, and the
unit returns to the normal condition.
4. Processing After the Destination Setting
Be sure to unsolder the SL501 on the MAIN board after doing the
destination setting.
– MAIN Board (Component Side) –
SL501
XAV-701BT/741
Ver. 1.2
] button.
] button.
Destination code
000003
000002
00000B
000004
Bluetooth
Navigation:
Destination: E3P
Region: 0
AP : SR06
IC502
5