THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• Y : Parts extracted from the conductor side.
•
: Internal component.
f
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen
(Conductor Side)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
Caution:
Pattern face side:
Parts on the pattern face side seen
(SIDE B)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(SIDE A)
the parts face are indicated.
• SERVO board is multi-layer printed board.
However, the patterns of intermediate-layer have not
been included in this diagrams.
• Indication of transistor.
C
Q
These are omitted.
B
E
• Abbreviation
RU
: Russian model
SAF
: South African model
Note: When the complete MAIN board is replaced, the
destination setting is necessary. Refer to "NOTE
THE MAIN BOARD OR SYSTEM CONTROLLER
(IC502) REPLACING" on page 5.
XAV-701BT/741
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
•
: Internal component.
f
• C : Panel designation.
Note: The components identifi ed by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specifi ed.
• A : B+ Line.
• B : B– Line.
• Power voltage is dc 14.4V and fed with regulated dc pow-
er supply from ACC and BATT cords.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
- SERVO board -
no mark : DVD PLAY
: Impossible to measure
*
- Other board -
no mark : TUNER (FM)
• Voltages are taken with VOM (Input impedance 10 M).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: AUDIO
J
: DISC PLAY
: USB
k
f
: TUNER
N
: MIC
: NAVI
h
E
: VIDEO
• Abbreviation
RU
: Russian model
SAF
: South African model
Note: When the complete MAIN board is replaced, the
destination setting is necessary. Refer to "NOTE
THE MAIN BOARD OR SYSTEM CONTROLLER
(IC502) REPLACING" on page 5.
• Circuit Boards Location
SENSOR board
DISPLAY board
D-SUB7 board
KEY7 board
35
35
XAV-701BT/741
Ver. 1.2
SERVO board
EXT-NAVI board
(E (PAL), South African, Russian models)
MOTOR board
MAIN board