Release Highlights; Accelerated Address Aging; Purpose; How It Works - 3Com 4007 Release Note

3com 4007: release note
Hide thumbs Also See for 4007:
Table of Contents

Advertisement

16
C
2: R
HAPTER
ELEASE
Accelerated
Address Aging

Purpose

How It Works

H
IGHLIGHTS
For all Layer 2 Switching Modules in Release 3.0.5, a third option has
been added to the
(other options are
agingOnly
If you select the
agingOnly
disabled on the module but the address table's aging interval will change
(becomes shorter) whenever the module detects that one of its links has
gone down. The objective is to flush addresses as quickly as possible.
Although STP is not operating on the module, this temporary, alternate
aging process draws upon a couple of the STP parameter values. These
can be system defaults or customized values.
Under normal operating conditions, the Layer 2 module uses the aging
interval value that you set in the
with the
agingOnly
of its links has gone down, the aging interval temporarily changes to the
value that you set in the
option. Usually, this interval is much shorter than the
and thus addresses age more quickly. After a period of time equal to
bridge spanningTree stpForwardDelay
seconds has transpired, a module then reverts to using the
stpMaxAge
value in
bridge agingTime
Essentially, the
agingOnly
ports go down, but does so without having STP enabled on the module.
The accelerated aging process affects all addresses in the Layer 2
module's address table; it is not limited to the addresses that are
associated with the down port.
This feature was not implemented on Layer 3 modules because it was not
needed. Whether STP is enabled or disabled, whenever a port has gone
down or is disabled, Layer 3 modules immediately flush all addresses that
are associated with that specific port.
bridge spanningTree stpState
and
enable
option, the Spanning Tree Protocol (STP) is
bridge agingTime
option selected, whenever a module detects that one
bridge spanningTree stpForwardDelay
as the aging interval.
option mimics the action that STP takes when
menu called
).
disable
command. However,
bridge agingTime
+
bridge spanningTree

Advertisement

Table of Contents
loading

Table of Contents