Table of Contents
Advertisement
13.0 - ELECTRICAL CONNECTIONS
Connect the unit positive to the
battery positive terminal or to one of its shunts
and con
nnect the negative output to the vehicle chassis.
ATTENTION
!
Unplug the battery negative before making any electric connection and
only reconnect it once all the connections have been made.
NB
: available vehicle model specification sheets can be downloaded:
www.gemini-alarm.com (private area
PIN
WIRE FUNCTION
- 1 -
Engine immobilizer NC contact
- 4 -
Auxiliary negative input
- 7 -
Ground
- 9 -
Engine immobilizer NO contact
- 10 -
Engine immobilizer relay common
- 15 -
Positive
- 16 -
Positive under key
JA
RED
BLACK
GREY
Engine immobilizer relay (NC)
WHITE-GREY
Engine immobilizer relay (NO)
WHITE
Engine immobilizer relay
(common)
).
WIRE COLOUR
GREY
YELLOW/GREEN
BROWN
WHITE/GREY
WHITE
RED
YELLOW
ALARM SYSTEMS
7892
Made in Italy
For all EU
15A
+
RED
Battery
12 VOLT
BROWN
Ground
YELLOW-GREEN
Auxiliary input (negative)
+30
YELLOW
Ignition
14.0 -
SYSTEM CONFIGURATION
After wring connections are completed, activate and configure the system as
follows
:
Make sure the SIM card is properly inserted and power the system
!
(reconnect the battery negative pole
Move the vehicle outside for better satellite reception
!
Turn ignition key ON for approx. 1 minute to get valid GPS data
!
ATTENTION
!
If you are unsure whether the first initialization has been done correctly,
repeat the operation by disconnecting the module and reconnecting it after
a few minutes.
If the system has been properly initialized, remotely configure the system as
follows
:
Turn ignition key OFF.
!
Send an SMS with the configuration string to the phone number of the SIM-
!
card installed in the unit (see par. 5.0 and 8.0).
If correctly configured, you will receive a confirmation SMS; otherwise you
!
will receive an error message.
15.0 -
CONTROL UNIT INSTALLATION AND MAINTENANCE
MyGTRACK systems are electronic devices which require suitable installation
and maintenance.
Fit the module in a horizontal position respect to the vehicle axis, in a well-
!
hidden position inside the vehicle cabin.
The module must be installed away from heat sources and potential water
!
infiltrations.
Only use manufacturer-specified voltages.
!
Do not clean the unit with water but use a damp cloth to wipe.
!
Do not remove warranty labels.
!
GEMINI TECHNOLOGIES DECLINES ANY LIABILITY FOR DAMAGES TO
THE SYSTEM DUE TO IMPROPER USE OR INSTALLATION.
).
.
.
Advertisement
Table of Contents
