Table of Contents
Advertisement
3.0 - ALARMS
3.1 - DISPLACEMENT ALARM
The system
provides protection against possible displacement attempts of the
vehicle when ignition is turned off ex. towing
(
When ignition is switched back "ON", the system compares the current
position with the position recorded upon last switch-off
If they differ (value above the factory set, unalterable, tolerance), the system
will send the user an alarm message.
The
P.P.C. function (par. 5.10) allows tracking vehicle position while the system
is armed.
ATTENTION
!
The "last valid position" is the vehicle last recorded position (lat., long.,
time and date) when ignition key is turned OFF.
The recorded position remains unvaried until ignition is turned back ON or
in case of an alarm or if the "periodic position control" command is
activated (the last two conditions are only available if the system is
armed).
3.2 - IGNITION DETECTION ALARM
ATTENTION
!
This alarm is only triggered if the "system arming" command
on#password#
has been previously sent par. 5.11 or 8.0) or if the
system has been armed via the
(par 5.14 or 8.0).
If someone breaks in the vehicle while the system is armed and attempts to
turn ignition ON
, the system
sends an alarm message.
After the message is sent to the 1st preset number, the system checks the
alarm source. If still active, it will be inhibited (ex. ignition key "ON"). If not active
(ex. ignition key "OFF") it wil be restored to guarantee protection again.
3.3 - BATTERY TAMPER ALARM
ATTENTION
!
This alarm is only triggered if the "system arming" command
on#password#
has been previously sent (par. 5.11 or 8.0) or if the system
has been armed via the
aux#password#n
The
system rovides protection against power source and wiring tampering. An
p
alarm will be triggered and an alarm message will be sent if power supply is cut-off
) and the
system disarmed
.
.
(
aux#password#n
command
command (par 5.14 or 8.0).
.
3.4 - GENERIC
ALARM (connection of
ATTENTION
!
Transmission of a generic alarm message is subject to connection of the
dedicated wire and system configuration by the installer.
When the message is sent, the system checks the alarm source. If still active, it
will be inhibited (i.e. door still open). If not active (i.e. door closed), it will be
restored to guarantee protection again.
4.0 - SUMMARY TABLE OF ALARM MESSAGES
In case of an alarm condition, the system sends a text message to the user
indicating the type of alarm (see table below).
SYSTEM
IGNITION KEY
STATUS
ALARM
ON
OFF
ARMED DISARMED
Position
(last stop)
Start
Power cut
Position
(PPC*)
Alarm
(AUX input= 0)
* Periodic Position Control.
Ignition detection, displacement (P.P.C.) and power cut-off alarms are subject
to tracker activation via SMS message or configuration of auxiliary input for
system arming via an external module.
The available configurations of the auxiliary input are detailed in par. 18.0.
All text messages provide vehicle position coordinates, speed, date and time.
An "over speed alarm" can also be forwarded to the 1st number only, when the
system is disarmed and ignition key is ON (par. 5.6).
yellow-green wire)
PHONE
REF.
1
2
st
nd
PAR.
number
number
3.1
3.2
3.3
5.10 and
8.0
3.4, 5.14
and 18.0
Advertisement
Table of Contents
