Table of Contents
Advertisement
16.0 - LEARNING NEW DEVICES
ATTENTION
Storing memory is for 13 devices.
Saving an extra device will automatically delete the first one.
To program new devices, proceed as follows:
! With the system disarmed, ground the GREEN-BROWN wire.
! Cycle ignition key ON-OFF 5 times in a row and leave it on OFF; the LED and
turn signals will flash twice.
!
WARNING
If, after cycling ignition ON-OFF, the key is left in the ON position for more
than 8 seconds all stored devices will be deleted.
!
Press the remote control button or make the sensors transmit (magnetic
contact and/orinfrared sensor).
!
The LED and turn indicators will flash once to confirm learning.
!
To learn another device, repeat the entire operation.
17.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE) as specified in art. 2.1 of
L.D. no. 151 of 25/07/2005.
18.0 - TECHNICAL SPECIFICATIONS
Power supply
Current absorption @ 12Vdc in standby
Current absorption @ 12Vdc in sleep-mode
Operating temperature range
Turn indicator output
Engine immobilizer relay capacity
Negative output in alarm
PAGE 16
19.0 -
AUXILIARY INPUT CONFIGURATION
(BROWN-GREEN wire)
The auxiliary negative input
allows for many connections and programming
modes.
According to customer needs
required SMS as indicated in the table below.
Refer to the user manual for the complete list of commands
ATTENTION
The system is configured with the BROWN-GREEN wire enabled with
system armed and a negative signal to trigger an alarm (aux1).
The alarm SMS is only forwarded to the main number.
COMMAND
ACTIVATION
aux#password#0
Input active 24h/7
Input active only
aux#password#1
when system is armed
aux#password#2
Input active 24h/7
Input active only
aux#password#3
when system is armed
Input active 24h/7
aux#password#4
(with ignition key
OFF)
Input active 24h/7
aux#password#5
(with ignition key
OFF)
Input active 24h/7
(with ignition key
aux#password#6
OFF)
Input active 24h/7
(with ignition key
aux#password#7
OFF)
aux#password#8
Input active 24h/7
aux#password#9
Input active 24h/7
* Positive means "lack of negative".
ATTENTION
With auxiliary inputs configured as '0-1-2-3' alarm messages will be sent
and the siren and turn indicators outputs will be active for approx. 30".
Inputs 8 and 9 are the only ones that can be deactived when the system is
in "Vehicle servicing mode" (see user manual).
, program the input by sending the
.
SIGNAL
Negative
Negative
Positive*
Positive*
Negative pulse arms system (with a
60" arming delay), negative pulse
disarms system
Positive* pulse arms system (with a
60"arming delay), positive pulse
disarms system
Constant negative arms system (with
a 60" arming delay), lack of negative
disarms system
Constant positive* arms system (with
a 60" arming delay), constant
negative disarms system
Negative
Positive*
PAGE 17
Advertisement
Table of Contents
