Table of Contents
Advertisement
8.0 - MESSAGE OVERVIEW
REQUEST
setup#password#version#main phone
Initial configuration and/or data
number#new password#emergency phone
modification
Initial configuration and/or data
setup#password#version#main phone
modification with STOP & GO
number#new password#emergency phone
activation
Initial configuration and/or data
setup#password#version#main phone
modification with STOP & GO
number#new password#emergency phone
deactivation
Vehicle localization
Tracking (vehicle displacement)
Speed control
Engine stop activation
Engine stop deactivation
SIM validity check
Periodic position control
System arming
System disarming
System status
Auxiliary input setup (AUX)
Indicative value, factory set, for the speed limit (expressed in km/h,
(Ref.01)
always 3 digits
).
Indicative value, factory set, for the time interval after which a
(Ref.02)
message must be sent (expressed in days, always 3 digits .
Indicative value, factory set, for the time interval after which vehicle
(Ref.03)
position must be checked (expressed in minutes, always 3 digits).
see par. 18.0.
(Ref.04)
9.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE) as specified in art. 2.1 of
L.D. no. 151 of 25/07/2005.
COMMAND
number#
number#f#
number#s#
loc#password#
trk#password#
speed#password#060
(ref.01)
stop#password#
go#password#
pol password#045
#
(ref.02)
pos#password#180
(ref.03)
on#password#
off#password#
status#password#
aux#password#n
(ref.04)
)
INSTALLER MANUAL
10.0 - GENERAL INSTALLATION ADVICE
Dear installer,
MyGTRACK systems are safety devices that provide full active protection to
12/24V vehicles via GPS location tracking and GSM communication (by
mobile phone).
IMPORTANT:
The MyGTRACK system you are about to install requires special attention
when fitting the GPS and the GSM antennas
The GSM antenna must be installed in a well-hidden but easily accessible
area of the vehicle with good GSM signa strength.
Particular attention must be paid when installing the GPS antenna: make
sure it is not covered by a metal surface (steel, aluminium, metallized
coating, etc.), as it will shield the GPS signal. Plastic and non metallized
material will not interfere withGPS signal reception.
The GSM and GPS antennas are very important system components on
which depend the good operation and the safety/protection of the vehicle.
ATTENTION
!
Remove the PIN code from the SIM card in use.
Some phone providers do not allow it, in this case set it to "0000".
.
Advertisement
Table of Contents
