Table of Contents
Related Manuals for Gemini My TRACK 955MyBasic
Summary of Contents for Gemini My TRACK 955MyBasic
- Page 1 955MyBASIC INSTALLER MANUAL GEMINI Technologies S.r.l. Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia Tel. +39 0332 943211 - Fax +39 0332 948080 www.gemini-alarm.com Made in Italy ISO 9001 Certified Company REV.00 - 06/17...
-
Page 2: Table Of Contents
2.0 - PRELIMINARY ADVICE 1.0 - TABLE OF CONTENTS Dear installer, - TABLE OF CONTENTS - PRELIMINARY ADVICE The present GEMINI tracker is a safety device designed to guarantee vehicle - OPTICAL SIGNALS protection GPS localization and GSM communication (by mobile phone). - Page 3 3.0 - O PTICAL S IGNALS WARNING The product you are about to install, requires special attention. The major FLASHES 1 LONG flash concern is the integrated GPS antenna. Proper placement is a key factor Module in the performance of the tracking device. initializing APPROX.
-
Page 4: Alarm Unit Positioning
For best performance, it is essential that the antenna has a “sky view”. Do not install the alarm unit in this Gemini label must face the vehicle frame. position because water may infiltrate trough the rubber cap and... -
Page 5: Sim Card
6.0 - SIM CARD 7.0 - ALARM UNIT SEALING WARNING DISCONNECT the alarm unit before carrying out the following operations. To seal the alarm, position the rubber cap over the external edge of the alarm housing as shown below. PRESS THE YELLOW BUTTON Pull the plastic rectangular flange ON THE SIDE OF THE SIM CARD over the rubber cap and secure with... -
Page 6: Pinout Table
8.0 - PINOUT TABLE IMMOBILIZER - cut wire Wire color Connections ATTENTION Attach to cut end of key switch wire This alarm system is intended for 12V turn indicators. White Before you do any electrical work, make sure the flashers are powered by a 12V signal. -
Page 7: Wiring Diagram
9.0 - WIRING DIAGRAM 10.0 - IMMOBILIZER WIRING DIAGRAMS ENGINE IMMOBILIZER - GROUNDED WIRE For most small 2-stroke motorcycle engines. White White/Grey Ground Key switch Immobilizer wire Status Orange Turn indicators Orange (12V) To vehicle engine Do not use Seat/topcase ENGINE IMMOBILIZER - CUT WIRE contact switch (recommended) -
Page 8: Diode Installation
! Protect the alarm unit from any direct water flow such as high-powered water jets found in a car wash. Diode inserted in vehicle wiring harness GEMINI TECHNOLOGIES WILL NOT BE HELD RESPONSIBLE FOR ANY DAMAGE CAUSED BY IMPROPER USE OR INSTALLATION. Live feed to indicator Vehicle original... -
Page 9: System Configuration
14.0 - SYSTEM CONFIGURATION 15.0 - PRE-ALARM AND ALARM After all the cabling has been completed, activate and configure the system. 15.1 - IGNITION ATTEMPT ALARM Make sure the SIM card is properly inserted in the drive tray and connect When ignition is switched ON without first disarming the system. -
Page 10: Learning New Devices
16.0 - LEARNING NEW DEVICES 19.0 - AUXILIARY INPUT CONFIGURATION (BROWN-GREEN wire) ATTENTION The auxiliary negative input allows for many connections and programming Storing memory is for 13 devices. modes. According to customer needs , program the input by sending the Saving an extra device will automatically delete the first one. - Page 11 R&TTE Declaration of Conformity Doc ref. No. 2010-01 NOTES We, the undersigned, Company GEMINI TECHNOLOGIES S.r.l. ________________________________________________________ Address, City Via Luigi Galvani 12, 21020 Bodio Lomnago (VA) Country Italy ________________________________________________________ Phone number +39 0332 943211 ________________________________________________________ Fax number +39 0332 948080...