Side-Discharging The Clippings; Operating Tips - Toro Recyler 20333 Operator's Manual

Figure 25
1. Bag-on-demand lever (in bagging position)
•
For recycling the grass and leaf clippings, press the button
on the lever and move the lever rearward until the button
on the lever pops up.
Important: For proper operation, remove any grass
clippings and debris from the bag-on-demand door and
the surrounding opening
the bag-on-demand lever from 1 position to another.
Figure 26
1. Clean here
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the grass bag is on the machine and the bag-on-demand
lever is in the Bagging position, move the lever to the
Recycling position; refer to
Lever (page 12).
(Figure 26) before you move
Operating the Bag-on-Demand
Installing the Side-Discharge Chute
Lift up the side deflector and install the side-discharge chute
(Figure 27).
Removing the Side-Discharge Chute
To remove the side discharge chute, lift up the side deflector,
remove the side-discharge chute, and lower the side-discharge
deflector.

Operating Tips

General Mowing Tips
•
Clear the area of sticks, stones, wire, branches, and other
debris that the blade could hit.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, disconnect the wire from
the spark plug, and examine the machine for damage.
•
For best performance, install a new blade before the
cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
13
Figure 27