Servicing The Air Filter; Changing The Engine Oil - Toro Recyler 20333 Operator's Manual

Servicing the Air Filter

Service Interval: Every 25 hours
1. Upclip the top of the air-filter cover
1. Clip
2. Air-filter cover
2. Remove the air filter
3. Inspect the air filter.
Note: If the air filter is excessively dirty, replace it with
a new filter. Otherwise, gently tap the air filter on a
hard surface to loosen debris.
4. Install the air filter.
5. Use the clip to install the air-filter cover.

Changing the Engine Oil

Changing the engine oil is not required, but if you desire
to change the oil, use the following procedure.
Note: Run the engine a few minutes before changing the
oil to warm it. Warm oil flows better and carries more
contaminants.
Max. fill: 0.53 L (18 oz), type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or higher.
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page
3. Remove the dipstick
(Figure
Figure 32
3. Air filter
(Figure 32).
16).
(Figure 33).
32).
1. Dipstick
4. Tip the machine onto its side with the air filter up to
drain the used oil out through the oil-fill tube
34).
5. Return the machine to the operating position.
6. Slowly pour about 3/4 of the crankcase capacity of oil
into the oil-fill tube.
7. Wait about 3 minutes for the oil to settle in the
crankcase.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick fully into the oil-fill tube, then
remove the dipstick.
10. Read the oil level on the dipstick
•
•
17
Figure 33
Figure 34
If the oil level is below the Add mark on the
dipstick, slowly pour a small amount of oil into the
oil-fill tube and repeat steps
oil level is at the Full mark on the dipstick.
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level on
the dipstick is at the Full mark.
(Figure
(Figure 33).
8 through 10 until the