Advertisement
Step by step assembly instructions
Step Nine
1.
With help of an assistant,
carefully stand up the unit upright.
Step Ten (only for base unit)
1.
Use 2x levelling wedge (GI) to level the unit.
Step Eleven
Fittings have been supplied in order to join units together.
1.
Place units together in their final positon.
2.
Decide position where to drill through using a Ø5 mm bit.
3.
Push the Connector (H) into the hole and then screw Bolt (I) in from the other side, tighten with a screw-
driver.
Ø5mm
GI
H
I
GI
Page 8
MXT 70 rev. 03 - 26/02/20
Advertisement
