Advertisement
Quick Links
MTO
Thank you for purchasing this Midcentury Sweep Bed. Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product.
PRE-ASSEMBLY PREPARATION
Please ensure instructions are read in full before attempting to assemble this product.
Necessary Tools
Please check the pack contents before attempting to assemble this product. A full checklist of components is
given in this leaflet. If any components are missing, please contact customer services on 01244 689949 or email
mail@fwgroup-uk.com.
This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE WHEN
LIFTING to avoid personal injury and (or) damage to the product.
This product takes approximately 40 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG CHILDREN.
Read this leaflet in full before commencing assembly.
Midcentury Sweep Bed
1 1
1/6
Double
Advertisement
Related Manuals for John Lewis Midcentury Sweep Bed
Summary of Contents for John Lewis Midcentury Sweep Bed
- Page 1 Midcentury Sweep Bed Double Thank you for purchasing this Midcentury Sweep Bed. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. PRE-ASSEMBLY PREPARATION Please ensure instructions are read in full before attempting to assemble this product.
- Page 2 Fitting and parts checklist Fittings M5 Allen Key x 1 M8 Spring Washer x 8 M13 Spanner x 1 Two-Ways Bolt x 4 Centre Caps x 7 Wide Centre Caps x 8 Side Caps x 14 Wide Side Caps x 16 M8 Washer x 4 M4 Allen Key x 1 M6 X 25mm Bolt x 2...
- Page 3 Step by step assembly instructions Step One Insert the Legs (7) into the pre-drilled holes on the Siderail (3). Twist the legs (7) to secure in place. (As per diagram below) Legs x 4 Step Two To attach the Side Rail (3) with the Headboard (1), start with inserting the Two-Ways Bolt (I) into the pre-drilled holes on the Siderail (3) as shown in Fig.
- Page 4 Step Three Starting with the Headboard (1) attach the Side Rails (3) using the M8 x 45mm Bolt (G) and M8 Spring Washer (H) into the pre-drilled holes on the Siderail (3). Please do not tighten the bolts yet. Repeat the step with the Footboard (3). Do not tighten with M5 Allen Key (A) until you have inserted the Centre Rail in the next step.
- Page 5 Step Five With the curved side facing upwards, insert 2 slats into a centre cap then into 2 side caps on either end(x15). (Please note the Wide Slats must be inserted with the Wide Centre Caps (J) and Wide Side Caps (K)). Repeat this process for all slats. Note: Please see the Diagram 1 below to arrange the slat with the correct system).
-
Page 6: Care And Maintenance
Care and Maintenance This bed should be cleaned using a soft, damp cloth and dried immediately. Do not use a very wet cloth or allow any liquid contact for a long period of time as this can permanently damage the surface. Do not use detergents and do not rub as this can cause permanent damage.