Table of Contents
Advertisement
Installation
Accessories
The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the
accessories shipped with the unit, as shown above.
A
B
C
Installation Procedure
1. To prevent short circuits, remove the key from the
ignition and disconnect the - terminal of the battery.
2. Make the proper input and output cable connections for
each unit.
3. Connect the speaker cables of the wiring harness.
4. Take Connector B on the wiring harness and connect it to
the speaker connector in your vehicle.
5. Take Connector A on the wiring harness and connect it to
the external power connector on your vehicle.
6. Install the unit in your car.
7. Reconnect the - terminal of the battery.
8. Press the reset button.
• If your car is not prepared for this special
connection-system, consult your KENWOOD dealer.
• Only use antenna conversion adapters (ISO-JASO)
when the antenna cord has an ISO plug.
• Make sure that all cable connections are securely
made by inserting jacks until they lock completely.
• If your vehicle's ignition does not have an ACC
position, or if the ignition cable is connected to a
power source with constant voltage such as a
battery cable, the power will not be linked with the
ignition (i.e., it will not turn on and off along with
the ignition). If you want to link the unit's power
with the ignition, connect the ignition cable to a
power source that can be turned on and off with the
ignition key.
• If the fuse blows, first make sure that the cables
have not caused a short circuit, then replace the old
fuse with one with the same rating.
• Do not let unconnected cables or terminals touch
metal on the car or anything else conducting
electricity. To prevent short circuits do not remove
38
D
E
F
G
H
I
J
K
the caps from unused terminals or from the ends of
the unconnected cables.
• Connect the speaker cables correctly to the
terminals to which they correspond. The unit may
receive damage or fail to work if you share the -
cables and/or ground them to any metal part in the
car.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Insulate unconnected cables with vinyl tape or other
similar material.
• During use, the surface temperature of this unit will
become high, therefore it should not be mounted
where anything sensitive to the heat, such as
people or resins, would come into contact with it.
• Do not install the unit under the carpet. Otherwise
heat build-up occurs and the unit may be damaged.
• Install this unit in a location which allows heat to
easily dissipate.
Once installed, do not place any object on top of the
unit.
• Install the unit securely in a location that does not
interfere with driving.
• Mount the monitor unit so that the mounting angle
is 30° or less.
Hide quick links:
Advertisement
Table of Contents
