Table Of Contents; Safety Information; Warranty; Pre-Assembly - Husky MR482478W5 Use And Care Manual

Table of Contents

Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Pre-Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Safety Information

CAUTION: Place the unit on a level surface. Failure to do
so can result in a safety hazard. This unit should be securely
anchored to a wall or fl oor with suitable fasteners, which are
not included.
CAUTION: Do not use this unit for anything other than the
manufacturer's intended purpose. Do not stand on any part
of the unit, or use it as a ladder. Use care when working with
metal parts.

Warranty

GUARANTEED FOREVER
If your Husky storage unit ever fails bring it back and we will replace it for free. This full warranty gives you specifi c rights which vary from
state to state. If this product is defective contact the manufacturer for replacement parts.
Contact the Husky Customer Service Team at 1-888-43-HUSKY or visit www.huskytools.com.

Pre-Assembly

PLANNING ASSEMBLY
Assembly of this unit is done by fi tting the rivets of the beams and braces into the slots of the posts.
The wire deck will rest on the ledge surface of the beam or brace depending upon the orientation of the shelf level.
The rivet should engage and fi t fi rmly into the tapered slot of the post. This engagement will apply resistance as it engages. A visual
inspection should be made to show that the rivet is properly engaged in the slot.
A rubber mallet should be used on the ledge of the beams and braces to properly seat the rivets. If a hammer is used care should be taken
to protect the beam or brace surface to avoid damage by using a protective cloth or block of wood. Tap gently to assure that all rivets are
straight and engaged. After assembly re-check each beam and brace for engagement.
Assembly Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Beam Orientation Options . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Shelf Orientation Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Alternative Confi guration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
CAUTION: Evenly distribute the weight on each level and
always keep the heavier loads on the bottom.
2