Husky MR481886W6B Quick Start Manual

Safety & General Instructions
This unit should be placed on a level surface and should be
securely anchored to a wall or floor with suitable fasteners,
which are not included. Failure to do so can result in a
possible safety hazard. Do not use this unit for anything
other than the manufacturer's intended purpose. DO NOT
STAND ON ANY PART OF THE UNIT OR USE AS A LADDER.
Use care when working with metal parts, wear gloves.
Evenly distribute the weight on each level and always keep
the heavier loads on the bottom.
The unit is assembled one level at a time. Each level is
assembled with two beams (b) and two braces (c) connected to
the posts (a) and one wire shelf (d). Assembly is done by fitting
the rivets of the beams and braces into the slots of the posts.
A rubber mallet should be used on the ledge of the beams and
braces to properly seat the rivets into the tapered ends of the
post slots. After assembly re-check each beam and brace for
engagement. The wire deck will rest on the ledge surface of the
beam or brace depending upon the orientation of the shelf level.
Retain this manual for future use.
Warranty
GUARANTEED FOREVER. If your Husky tool or storage unit
ever fails bring it back and we will replace it for free. This full
warranty gives you specific rights which vary from state to state.
If this product is defective contact the manufacturer for repair or
replacement parts.
Should you have questions, problems, damage or missing parts, contact us for assistance:
Chat: www.edsal.com/chat or www.edsal.com/contact
Email: support@edsal.com
Phone: 773‐475‐3131
To obtain replacement parts please provide: Model Number, Part Number & Description, Location Purchased, and Date Purchased
Model MR481886W6B
(48"w x 18"d x 86"h)
Components
A: post
E: post
coupler
Description
A. post
B. beam
C. brace
D. wire shelf
E. post coupler
F. post cap
G. post foot
Recommended Items for Assembly
Rubber Mallet (preferred) or Hammer (protect surface with cloth
or wood block) and Gloves
B: beam (long)
D: wire shelf
F: post
cap
PARTS LIST
Component Nominal
URPS43-BLK
TRBM48-BLK
TRBR18-BLK
1848W 18" x 48"
CPOUT-BLK
RL-PC-B1
FP-HP
Manufacturer:
Edsal Manufacturing Company
Chicago, IL 60609
Assembled in U.S. with global and domestic components
US Patents & Patents Pending
C: brace (short)
G: post
foot
Quantity
Size
43" 8
48" 12
18" 12
6
-- 4
-- 4
-- 4
Rev: C061518