Names Of The Terminals On The Rear Panel; Preparing And Using The Remote Control - Toshiba TLP-X100U Owner's Manual

Names of the terminals on the rear panel

(1) (2) (3)
(6) (7)
(8) (9)
Name : Main Function
(1) AUDIO IN terminal : Input audio signals from a computer or video equipment.
(Multiple use for COMPUTER 1 IN/2 IN, VIDEO and
S-VIDEO)
(2) S-VIDEO terminal : Input S video signals from video equipment.
(3) COMPUTER 1 IN (Y/P /P 1) terminal
B R
: Input analog RGB signal from a computer, or a
component video signal (Y/P
(4) COMPUTER 2 IN (Y/P /P 2) terminal/MONITOR OUT terminal
B R
: Inputs analog RGB signal from a computer
or a component video signal (Y/P
equipment.
It can also be used as MONITOR OUT terminal by the
switch of (5).
(5) Switch : Switches between COMPUTER 2 IN and MONITOR OUT.
(6) AC IN socket : Connects the supplied power cord here.
(7) AUDIO OUT terminal : Outputs audio signals.
(8) VIDEO terminal : Input video signals from video equipment.
(9) CONTROL terminal : When operating the projector via a computer, connect this
to the controlling computer's RS-232C port.
(4)
(5)
/P ) from video equipment.
B R
/P ) from video
B R
p.55
18

Preparing and using the remote control

Loading dry-cell batteries
■
into the remote control
Remove the battery cover.
1
Insert the dry-cell batteries.
2
Be sure to align the plus and minus ends
of the batteries properly.
Two batteries (R03, SIZE AAA) are used.
Replace the battery cover.
3
Dry-cell batteries
• Before using the batteries, be sure to observe the Safety Precautions described in
previous pages.
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries
with new ones. (2 batteries (R03, SIZE AAA))
• Keep the batteries away from the reach of children.
Batteries are choking hazards and can be very dangerous if swallowed. If the batteries
are swallowed, seek medical assistance immediately.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not allow it to get wet or place it on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If
this happens, point the remote control at the main unit again, and repeat the operation.
Operating the remote
■
control
Point toward the projector's infrared
remote sensor, and press any button
on the remote control.
• Operating the projector from the front
Approx.15°
When operating the remote control
from behind the projector, the infrared
signal is reflected on the projecting
surface and may travel a shorter
distance to reach the projector
depending on the shape and material
of the projecting surface.
19