Connection - Toshiba TLP-X100U Owner's Manual

Connection

Before connection
• Read the owner's manual of the device you are connecting to the projector.
• Some computers cannot be used with or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figure below shows sample connections. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Video recorder,
DVD player, etc.
To audio
To
To
S-video cable
output
S-video
video
(not supplied)
White (L)/ output
output
Red (R) To RGB output
RGB cable
(supplied)
Video cable
(not supplied)
Audio cable
(not supplied)
Audio cable
(not supplied)
Control
cable (not
Audio cable
supplied)
(not supplied)
To audio intput
White (L)/Red ( R)
Audio amplifier, etc.
* The connection for COMPUTER 1 IN terminal described here is also applicable for COMPUTER 2 IN terminal.
, etc.
p.53
Computer DVD video recorder, etc.
Conversion adapter
BNC-pin (not supplied)
To Y/C /C output
B R
Green(Y)/Blue(C )/
B
Red (C )
R
To audio
ouput
Monitor cable Mini
D-sub 15P-BNC
(not supplied)
Audio cable (not supplied)
To RS-232C Monitor
terminal
p.55
Computer (for control) It is necessary to switch
to MONITOR
p.18
OUT by the switch.
22
Notes
• When COMPUTER 2 IN terminal is used as MONITOR OUT terminal, the signal which is
input to COMPUTER 1 IN terminal is output.
• Signals are output from MONITOR OUT terminal even in standby mode.
However, from AUDIO OUT terminal, no audio signal is output.
• A computer monitor cannot accept Y/P
• The AUDIO IN terminal can be used for devices connected to COMPUTER 1 terminal,
COMPUTER 2 terminal, VIDEO terminal and S-VIDEO terminal.
• When an AUDIO OUT terminal is connected, sound is not output from the projector speaker.
• Output volume of AUDIO OUT terminal can be adjusted by the VOL button.
To audio
ouput
White (L)/
Red (R)
/P signals correctly.
B R
23