SECTION 3
3.9 Torch Mounting
CAUTION
1.812 " (46mm)
Diameter Collar
Do Not Cover Vent Hole.
When mounting, do not to cover the small vent
hole in the side of the sleeve. This hole allows
coolant to drain from inside the sleeve should a
leak occur in a service line.
Torch Mounting Options.
Torch Mounting Options.
Torch Mounting Options.
Torch Mounting Options.
2.0 " (51mm)
Diameter Sleeve
•
•
•
Vent Hole
Precision Plasma with Integrated Flow Control
Precision Plasma with Integrated Flow Control
Precision Plasma with Integrated Flow Control
Precision Plasma with Integrated Flow Control
The torch is normally mounted by the 2.0 inch
diameter (51mm) sleeve. Do not cover vent hole.
For custom alternative mounting, the torch can be
mounted by the 1.812" (46 mm) dia collar shown.
This insulated collar and its shoulder are machined
relative to the nozzle retainer thread on the torch
body.
Use only specified mounting surfaces
INSTALLATION
3-11