Table of Contents
Advertisement
SECTION 4:
CUTTING OPERATION
4.01 ONE TORCH SET
Follow the instructions below to prepare your machine for operation:
1. Gently remove the machine from its case and set it on the rail.
2. Assemble the torch set parts in the following order;
a. Insert the rack bar into the main unit in the direction of the arrow.
b. Fit the torch holder onto the rack bar as shown.
c. Fit the torch into the torch holder and adjust the torch up/down setting.
d. Fit the hoses between the torch and gas distributor connection. (The blue hose has a right-hand thread,
and the fuel hose has a left-hand thread).
e. When the torch stroke in insufficient to cut the plate beneath the rail when carrying out lower-edge
preparation, change the torch holder to the position indicated by the arrow.
3. Refer to the Cutting Data (see page 19) to select the right cutting nozzle for the thickness of steel plate to be cut.
4. Always use two spanners to tighten the nozzle on the torch. This is to avoid damaging the torch.
4.02 TWO TORCH SET
1. Insert the rack bar into the main unit in the direction of the arrow.
2. Fit the two cross-feed torch holders onto the rack bar.
3. Position and fix the torch holders into the cross-feed holders, then fit the torches.
15
Advertisement
Table of Contents
