Lubrication; Greasing The Bearings, Bushings, And Pivots - Toro Groundsmaster 3400 Operator's Manual

Lubrication

Greasing the Bearings,
Bushings, and Pivots
Service Interval: Every 50 hours
Grease Type: No. 2 lithium or molybdenum grease
1. Grease every 50 hours
1
1
1
1
1
Lubricate bearings and bushings immediately after every
washing, regardless of the interval listed.
Replace any damaged grease fittings.
Grease all grease points and ensure that sufficient grease is
injected such that clean grease is seen to escape. This ensures
maximum working life.
The grease fitting locations are as follows:
1
Figure 32
33
1
1
1
1
G018090