Table of Contents
Advertisement
Premaintenance
Procedures
General Safety
WARNING
Improperly servicing or repairing the machine can
cause injury or death.
If you do not understand the service procedures
for this machine, contact an Authorized Toro
Service Dealer or obtain the service manual for this
machine.
WARNING
Leaving a machine with raised attachments
unattended can cause injury or death.
Before you leave the operating area, always support
or lower the equipment to the ground and stop the
engine.
WARNING
Replace all covers and guards after you service or
clean the machine. Never operate the machine
without the covers or guards in place.
1. Park the machine on a level surface.
2. Lower all attachments, stop the engine, and remove
the key.
3. Allow the engine to cool 2 or 3 minutes.
4. Remove the right-side panel; refer to
Side Panels (page
46).
5. Rotate the battery-disconnect switch to the Off
position; refer to
Battery-Disconnect Switch (page
Lubrication
Greasing the Machine
Grease Type: Lithium-based grease.
Greasing the Front and Rear Axles
Service Interval: Every 250 hours
1. Clean the grease fittings with a rag.
2. Connect the grease gun to the grease fittings for the
Removing the
1. Grease fitting (upper pivot) 2. Grease fitting (lower pivot)
21).
44
upper and lower pivots; apply 2 or 3 pumps of grease
to each fitting
(Figure 59
and
Note: There are 2 grease fittings at the axle pivot for
each tire.
Figure 59
Front axle
Figure
60).
Advertisement
Table of Contents
