Panasonic LP-GS Series Serial Communication Command Manual page 49

⿎ Change the marking characters and start marking
1. Laser pumping (ON)
2. File selection by number
3. Character entry
4. Shutter open
5. Status checking
Marking trigger ready: ON
6. Marking trigger
No: Mark the same
characters
10. Shutter close
11. Laser pumping (OFF)
12. Overwrite file
*1 : From sending the laser pumping on request to completion of laser pumping, the following time will be required.
• LP-GS series: about 8 to 15 seconds
• LP-RC series: about 10 seconds
• LP-RF series: about 7 seconds
*2 : Commands from No. 2 to No. 5 above chart can be sent right after turning on laser pumping (without waiting for the
laser pumping completion).
*3 : There is a delay time of around 200ms to max. 1 second from sending shutter open/close command for the actual
shutter open/close operation time.
Besides, with LP-RC series for the first operation of opening shutter after the laser pumping on, it takes around 300ms
to max. 4 seconds.
Remote mode ON
LSR command
FNO command
STR command
SHT command
STS command
Yes
MRK command
Change the character
to be marked
No: Finish
operation
SHT command
LSR command
FOR command
Remote mode OFF
*1, *2
Transmit the characters you want to mark
*3
No.
Yes
7. Command reception permission ON
8. Character entry
9. Command reception permission OFF
To save the character marked last, transmit
the "Overwrite file FOR" command.
ME-LPGS-SR-5
MKM command
STR command
MKM command
49