Panasonic LP-GS Series Serial Communication Command Manual page 119

⿎ Readout request data
Start
PRD
code
⿎ Response data for readout
Start
PRD
code
⿎ Data description
Name length
Object No. Max. 4*
Point No. Max. 2*
Settings status
Time unit
Radiation time
Laser power
correction
X-position
Y-position
Total data length
* Readout request data are variable length.
⿎ Data example
Condition: Object No. = 1, Point No. = 0, Setting status = 1, Time unit = 1, Radiation time = 2000,
Laser power correction = 100, X-position = 25.5, Y-position = -7
• Readout
Transmission data
Response data
[Object No.], [Point No.]
R
Max. 7-byte
[Object No.], [Point No.], [Settings status],
[Time unit], [Radiation time],
A
[Laser power correction], [X-position], [Y-position]
Data
Data content
[byte]
"0000"–"1999"
"00"–"49"
"0": No settings
1
"1": Settings exist
"0": ms
"1": s
1
"2": min
"3": h
With time unit "ms" or "s":
"00000.1"–"99999.9" [ms], [s]
With time unit "min":
7
"00000.1"–"02880.0" [min]
With time unit "h":
"00000.1"–"00048.0" [h]
3 "000"–"999" [%]
8
"-999.999"–"+999.999" [mm]
8
41 It is the length including the separator ",". The response data length is fixed.
or • When the specified point no. has settings : 41-byte
9 • When the specified point no. has no settings : 9-byte
[STX] PRD
[STX] PRD
(Check
sum)
41-byte or 9-byte
Reads out the point radiation setting by a
point.
It is not possible to readout settings for the
multiple points at once.
• If there is no setting in the specified point
• The correction ratio of laser power is
R 1,0 [CR]
A 0001,00,1,1,02000.0,100,+025.500,-007.000
ME-LPGS-SR-5
End code
(Check
End code
sum)
Remarks
no., these items are not included in the
response data for readout.
calculated using the value set at the
laser settings as 100%.
[CR]
119