Panasonic LP-GS Series Serial Communication Command Manual page 137

Name Omit
Laser power
Y
correction
Total data length
* Setting request data are variable length.
⿎ Example of command settings
Condition: Adjustment No. = 0, Adjustment object = 1, Object group No. = 0, Target row = 2,
Target column = 3, Adjustment item = 0, X-movement = 0.1, Y-movement = -0.2, Z-movement = 0.3,
Rotation movement = 2.1, Laser power correction = -20
• Setting
Transmission data
• Readout
Transmission data
Response data
Condition: Adjustment No. = 0, Adjustment object = 1, Object group No. = 3, Target row = 3, Target column = 3,
Adjustment item = 1
• Setting
Transmission data
• Readout
Transmission data
Response data
Reference
• When the adjustment item is set to Mark OFF, the subsequent data after X-movement do not exist in the response data
for readout.
⿎ Setting request data / response data for readout: when adjustment object is row or column
Start Sub
SRA
code command
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Data description
Name Omit
Adjustment
–
No.
Adjustment
–
object
Object group
–
No.
Data length
[byte]
Max. 3* "-50"–"+50" [+/-%]
60 It is the length including the separator ",".
[STX] SRA
[STX] SRA
[STX] SRA
[STX] SRA
[STX] SRA
[STX] SRA
[Adjustment No. ], [Adjustment object], [Object group No.],
[Start row/column], [Last row/column], [Adjustment item],
[X-movement], [Y-movement], [Z-movement],
[Rotation movement], [Laser power correction]
Data
length Data contents
[byte]
Max. 3* "000"–"999"
"2": Row
1
"3": Column
Max. 4* "0000"–"1999"
Data contents
S 0,1,0,2,3,0,0.1,-0.2,0.3,2.1,-20
R 0 [CR]
000,1,0000,002,003,0,+000.100,
A
-000.200,+000.300,+002.100,-20
S 0,1,3,3,3,1 [CR]
R 0 [CR]
A 000,1,0003,003,003,1
Max. 60-byte
ME-LPGS-SR-5
Remarks
Corrects the laser power of the
marking data in the range of
rows/columns specified.
Specify the correction ratio in
the range of 100±50% relative
to the laser power for the object
to which Step & repeat applies.
[CR]
[CR]
[CR]
(Check
sum)
Remarks
Specifies an object group number with
Step & repeat set.
End
code
137