Mercedes-Benz GLC Series Operator's Manual page 342

340 Wheels and tires
Alignment bolt
R
The tire-change tool kit is located under the
cargo compartment floor.
%
Depending on the model, the tire-change
tool kit may be located in other positions
under the cargo compartment floor.
1 Jack
2 Ratchet for jack
3 Lug wrench
4 Folding chock
5 Alignment bolt
6 Socket wrench for ratchet
Preparing the vehicle for a wheel change
Requirements:
The required tire-change tool kit is available.
R
If your vehicle is not equipped with the tire-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
R
ground.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Vehicles with automatic transmission:
#
Shift into position j.
Vehicles with level control system: Set the
#
normal vehicle level ( page 208).
/
Switch off the engine.
#
Make sure that the engine cannot be started.
#
Place chocks or other suitable items under
#
the front and rear of the wheel that is diago‐
nally opposite the wheel you wish to change.
If necessary, remove the wheel trim/hub
#
caps ( page 340).
/
Raise the vehicle ( page 341).
/
#
Removing and installing the wheel trim/hub
caps
Requirements:
The vehicle is prepared for a wheel change
R
( page 340).
/
Plastic hub cap
To remove: turn the center cover of the hub
#
cap counter-clockwise and remove the hub
cap.
To install: make sure that the center cover
#
of the hub cap is turned counter-clockwise.