Display Problems - Toshiba 4010 User Manual

To remove the cap:
1 Firmly grasp the cap and pull it straight up.
Removing the AccuPoint II cap
2 After cleaning the cap, position it on the peg and press it
into place.
NOTE: The peg is square, so be careful to align the cap's hole with
the peg.

Display problems

Here are some typical display problems and their solutions:
The screen is blank.
Display Auto Off may have gone into effect. Press any key to
activate the screen.
You may have activated the instant password feature by
pressing
password, press any key, type the password and press
no password is registered, press any key. The screen
reactivates and allows you to continue working.
If you are using the built-in screen, make sure the display
priority is not set for an external monitor. To do this, press
and
F5
problem, press
display priority to its previous setting.
and simultaneously. If you have registered a
Fn F1
simultaneously (once). If this does not correct the
and
Fn
If Something Goes Wrong
Resolving a hardware conflict
simultaneously again to return the
F5
211
. If
Enter
Fn