Connections; Setting Up The Wifi Base; Remote Upgrade Wi-Fi Base; V300 Camera Display - Motorola V300 User Manual

Connections

while the V300 Camera is docked in the transfer station.
After you place the camera in the WiFi base, the camera associates, then the power LED fast
blinks amber while the upgrade is copied to the base. The power LED then slow blinks amber
signaling a pending upgrade. To apply the upgrade, power cycle the Wi-Fi base.

V300 Camera display

When V300 is paired with the WiFi base, the camera display shows a Wi-Fi Signal Strength icon
( ) that indicates the strength of the Wi-Fi signal coming from the WiFi base.
Infrequent screens seen on the
V300 UI
The UI screens shown here do not appear frequently or are of very short duration.

Disk full

When the camera has less than 2% of storage available, the SD card element flashes (1 second
ON, 1 second OFF). After the camera fills completely, any attempt to record is blocked and the
screen displays FULL.
V300 Body-Worn Camera User Guide
WGD00169 Revision C
The WiFi base has connections for a Wi-Fi
antenna cable and a provided custom power and
data cable on the back.

Setting up the WiFi base

Typically, the WiFi base and the Distributed
Multi-Peer Recording are installed in the vehicle
by your agency installation technicians. For more
information about installing the V300 system
equipment in the vehicle, see the 4RE Vehicle
Installation Instructions.

Remote upgrade Wi-Fi base

The upgrade file for the WiFi base is downloaded
Connections
65