Motorola V300 User Manual page 21

1 Back of the mount
2 Front of the mount
3 Forked end goes on bottom row of loops, over the sewn seam
4 Support loop hooks that go on top row of loops
5 Upper two hooks that slide over top row
6 Camera tabs to seat the camera in the mount
To use the MOLLE vest mount:
1. Determine which two rows of loops on the MOLLE vest you want to use to mount the V300
Camera.
2. Slide the forked end down over the sewn seam, on the lower of the two rows, between the two
loops until the hook is engaged below the seam.
You may need to slightly twist the mount to help the hook slide over the seam.
3. Fold the fabric between the two rows so that the support loop hooks engage two loops on the
upper row of loops.
4. Slide the upper loop hooks down over the two loops, straightening the fabric between the rows, to
fully seat the mount.
The forked end should be fully engaged with the seam on the lower row of loops. The hooks
should be fully engaged with two loops on the upper row of loops.
5. Align the V300 Camera with the two tabs on the bottom of the mount and snap the camera in to
the mount.
To unmount the camera
1. Pull straight up on the camera and battery.
2. Lift out the V300 camera and battery.
V300 Body-Worn Camera User Guide
WGD00169 Revision C
MOLLE vest mount
21