Maintenance; Recommended Maintenance Schedule(S); Maintenance Safety; Preparing For Maintenance - Toro 20340 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
Replacement parts are available from an Authorized Service
Dealer or at www.torodealer.com (US customers only).

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
Before each use or daily
Before storage
Yearly
Important: Refer to your engine manual for additional maintenance procedures.

Maintenance Safety

•
Disconnect the spark-plug wire from the spark plug
before performing any maintenance procedure.
•
Wear gloves and eye protection when servicing the
machine.
•
The blade is sharp; contacting the blade can result in
serious personal injury. Wear gloves when servicing the
blade.
•
Never tamper with safety devices. Check their proper
operation regularly.
•
Tipping the machine may cause the fuel to leak. Fuel is
flammable and explosive, and can cause personal injury.
Run the engine dry to remove the fuel with a hand pump;
never siphon the fuel.

Preparing for Maintenance

1. Shut off the engine and wait for all moving parts to
stop.
2. Disconnect the spark-plug wire from the spark plug
(Figure 24).
Maintenance Procedure
• Check the engine-oil level and add oil as needed.
• Ensure that the engine stops within 3 seconds after releasing the blade-control bar.
• Clean grass clippings and dirt from under the machine.
• Empty the fuel tank before repairs as directed and before annual storage.
• Clean the air cooling system; clean it more frequently in dusty operating conditions.
Refer to your engine owner's manual.
• Service the air filter; service it more frequently in dusty operating conditions.
• Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
• Refer to your engine owner's manual for any additional yearly maintenance
procedures.
1. Spark-plug wire
3. After performing the maintenance procedure(s),
connect the spark-plug wire to the spark plug.
Important: Before tipping the machine to change
the oil or replace the blade, allow the fuel tank to
run dry through normal usage. If you must tip
the machine prior to running out of fuel, use a
hand fuel pump to remove the fuel. Always tip the
machine onto its side, with the dipstick down.
16
Figure 24
g186014