Servicing The Air Filter; Changing The Engine Oil - Toro 20340 Operator's Manual

Servicing the Air Filter

Service Interval: Yearly
1. Unclip the top of the air-filter cover
1. Clip
2. Air-filter cover
3. Air filter
2. Remove the air filter
3. Inspect the air filter.
Note: If the air filter is excessively dirty, replace it with
a new filter. Otherwise, gently tap the air filter on a
hard surface to loosen debris.
4. Install the air filter.
5. Use the clip to install the air-filter cover.

Changing the Engine Oil

Changing the engine oil is not required, but if you desire
to change the oil, use the following procedure.
Note: Run the engine a few minutes before changing the
oil to warm it. Warm oil flows better and carries more
contaminants.
Engine oil capacity: 0.47 L (16 oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
(Figure
Figure 25
(Figure 25).
16).
(Figure 26).
25).
4. Tip the machine onto its side (so that the air filter is
up) to drain the used oil from the oil-fill tube
27) or set the machine in the vertical-stow position
(Figure
g186256
17
Figure 26
28).
Figure 27
g186245
(Figure
g186039