Assembling The Unit - Stihl KombiTool HT-KM 4182 Instruction Manual

Assembling the Unit

Pull the protective caps off the ends
N
of the shaft and keep them in a safe
place for later use – see "Storing the
Machine"
NOTICE
The plug may come out of the drive tube
when you pull off the cap. Push it back
into the shaft as far as it will go.
HT-KM
Mounting the gearbox
A
Apply a mark to the shaft at distance
N
(A) of 50 mm (2 in.)
2 1
Push the gearbox (1) onto the
N
shaft (2) as far as stop – turn the
gearbox back and forth until the
square end of the shaft engages
The gearbox is correctly positioned
when the end of its housing reaches or
covers the mark (arrow).
3
1
3
Insert the clamp screws (3) as far as
N
it will go
1
Line up the gearbox (1) so that the
N
chain sprocket cover is exactly
vertical and the lug (arrow) on the
end of the drive tube faces up
Tighten down the clamp screws (3)
N
in the following sequence:
tighten the left screw moderately
–
tighten the right screw moderately
–
tighten down the left screw firmly
–
tighten down the right screw firmly
–
English
9