Stihl KombiTool HT-KM 4182 Instruction Manual page 9

The shaft should always be held at an
angle of 60° or less.
The least tiring working position is a tool
angle of 60°.
Any lesser angle may be used to suit the
situation.
Cross-cut
To avoid pinching the bar in the cut,
position the cutting attachment with the
hook against the branch and then
perform the cross-cut from the top
downwards.
HT-KM
Relieving cut
2
To avoid tearing the bark on thick
branches, always start by performing a
relieving cut (1) on the underside of
N
the branch. To do this, position the
cutting attachment and guide it
down to the bar nose in an arc.
Perform the cross-cut (2) – position
N
the bar with the hook against the
branch and then perform the cross-
cut
Flush-cutting thick branches
1
If the branch diameter is more than
10 cm (4 in), first
perform the undercut (3) and then
N
cross-cut at a distance of about
20 cm/8 in (A) from the final cut.
Then carry out the flush-cut (4),
starting with a relieving cut and
finishing with a cross-cut
English
A
3
4
7