Assembling The Unit - Stihl HL 100 Instruction Manual

1)
Must not be mounted to versions
with short shaft (HL 95 K,
HL 100 K)
2)
Loop handle required
3)
May be mounted to versions with
handle hose and long shaft (HL 95,
HL 100)
HL 95, HL 95 K, HL 100, HL 100 K

Assembling the Unit

Mounting the Loop Handle
Necessary on versions with long drive
tube and 135° adjustable cutter bar (not
on HL 95 K, HL 100 K).
7
8
2
3
6
9
Place the clamp (1) in the loop
N
handle (2) and position them both
against the drive tube (5) between
the carrying ring (3) and handle
hose (4).
Place the clamp (6) against the
N
drive tube.
Line up the holes.
N
Insert the screws (7) with
N
washers (8).
Fit the square nuts (9) and screw
N
home the screws.
7
8
Align the loop handle (2) and move
N
it to the most comfortable position.
1
Distance (A) must not be more than
55 cm (recommended: about 35 cm).
Tighten down the screws firmly.
N
9
English
A
2
11