Table of Contents
Advertisement
Installation on a Wall
Installing the Solar Collectors
*
Legend
Collector connection
Spacer lip on connecting brace
Rating plate
a ≈ 9" / 230mm
Note:
See page 25 for numbered component
description.
* See page 8 for numbered component
description.
IMPORTANT
The top connecting brace
omitted on larger collector arrays to
ensure that the collectors stay aligned
vertically.
28
(continued)
a
may be
5. Position the first collector into the
retaining plates and push right up
to the spacerlip of the connecting
brace. Center the distance when
fitting only a single collector.
IMPORTANT
Install the collector panel so that the
rating plate side of the first and last
collector is on the outside (note
sticker)! If only one collector is to be
installed, connect the piping opposite
the nameplate side. See page 14 for
more information.
6. Before inserting interconnection
pipe
* mark the middle of the
connecting pipe with a marker or a
piece of tape for reference. Insert
the connecting pipe into the
collector until the brass section is
no longer visible.
IMPORTANT
Interconnection pipes should not show
any signs of damage.
Lubricate all plug-in connectors (O-rings)
found on the collectors only with the
special grease supplied with the
connection set.
7. Carefully push the next collector up
to the spacer lip
and insert the
interconnecting pipes as far as
possible until they are centred
between the collectors.
8. Click clamping brackets
collector edge at the top of all
supports.
9. Secure the connecting brace
turned by 180° to the next brace
using clamping brackets
between the second and third, the
fourth and fifth supports etc.
10.The distance between collectors
should be no greater than the width
of the spacer lip
on the
connecting brace
.
11.Tighten all screws.
12.Fit a snow guard on the roof above
the collectors, as required.
into the
Advertisement
Table of Contents
