Table of Contents
Advertisement
Installing Freestanding Installation
10.
*
Collector connection
Spacer lip on connecting brace
Rating plate
Note:
See page 16 for numbered component
description.
* See page 8 for numbered component
description.
(with ballast weight inserts - for Model SH only)
14.
13.
9.1"/
232 mm
11.
10.Position the first collector into the
Install the collector panel so that the
rating plate side of the first and last
collector is on the outside (note
12.
sticker)! If only one collector is to be
installed, connect the piping opposite
the nameplate side. See page 14 for
more information.
11. Before inserting interconnection
Interconnection pipes must be free from
damage and contamination. Lubricate all
plug-in joints (O-ring seals) on the
collectors. Use only the special grease
supplied with the connection set.
12. Carefully push the next collector up
Ensure interconnection pipe is centered
between collectors.
13. Click clamping brackets
14. Secure the connecting brace
15. The distance between collectors
16. Tighten all screws.
Installation on Flat Roofs
or Freestanding Installation
retaining plates and push right up to
the spacer lip of the connecting
brace. Center the distance when
fitting only a single collector.
IMPORTANT
pipe
*, mark the middle of the
connecting pipe with a marker or a
piece of tape for reference. Insert
the interconnection pipe into the
collector until the brass section is
no longer visible.
IMPORTANT
to the spacer lip and insert the
interconnecting pipes as far as
possible.
IMPORTANT
collector edge at the top of all
supports.
turned by 180° to the next brace
using the clamping brackets
between the second and third, the
fourth and fifth supports, etc.
should be no greater than the width
of the spacer lip
on the
connecting brace
.
into the
23
Advertisement
Table of Contents
