Table of Contents
Advertisement
Installation on Flat Roofs
or Freestanding Installation
Installing Freestanding Installation
7.
*
1.25"
Legend
Collector connection
Spacer lip of the connecting brace
Rating plate
Note:
See page 15 or 16 (depending on
model) for numbered component
description.
* See page 8 for numbered component
description.
20
(on substructures)
11.
10.
9.1"
8.
7. Position the first collector into the
retaining plates
to the spacer lip of the connecting
brace
.
IMPORTANT
Install the collector panel so that the
rating plate side of the first and last
collector is on the outside (note
sticker)! If only one collector is to be
installed, connect the piping opposite
the nameplate side. See page 14 for
more information.
9.
8. Before inserting interconnection pipe
mark the middle of the connecting
pipe with a marker or a piece of tape
for reference. Insert the inter -
connection pipe
until the brass section is no longer
visible.
IMPORTANT
Interconnecting pipes must be free from
damage and contamination. Lubricate all
plug-in joints (O-ring seals) on the
collectors. Use only the special grease
supplied with the connection set.
9. Carefully push the next collector up
to the spacer lip and insert the
interconnection pipes as far as
possible until they are centered
between the collectors.
IMPORTANT
Ensure interconnection pipe is centered
between collectors.
10. Click clamping brackets
collector edge at the top of all
supports.
11. Secure the connecting brace
turned by 180° to the next brace
using the clamping brackets between
the second and third, the fourth and
fifth supports, etc.
12. The distance between collectors
should be no greater than the width
of the spacer lip on the connecting
brace
.
13. Tighten all screws.
and push right up
* into the collector
into the
Advertisement
Table of Contents
