Chapter 12 Display And Operation Settings (Got Set Up); Display Settings; Display Setting Functions - Mitsubishi Electric GOT SIMPLE Series User Manual

12
DISPLAY AND OPERATION SETTINGS (GOT
SET UP)
The setting screens related to the display or operation can be displayed from the utility screen.
In the setting screen for display and the setting screen for operation, the following settings can be set.
Item Description

Display settings

Setting the title display period and screen saving time
Brightness
Operation settings Setting buzzer volume, window move buzzer, and key reaction speed
Touch panel calibration
Utility call key
12.1
Display Settings

Display setting functions

Setting regarding display is possible.
The items which can be set are described below. If touch the each item part, the respective setting becomes possible.
Item Description
Opening time The title display period at the main unit boot can be set.
Screen save time The period from the user stops the touch panel operation till the screen save function
starts can be set.
Brightness Brightness can be adjusted.
Page 107 Brightness
*1 Even if 0 is set, the title screen is still displayed. The title screen is always displayed for 4 seconds or more (depending on the project
data).
• Display setting by GT Designer3
Set title display period, screen save time and screen save backlight by selecting [Common]
Environmental Setting]
When change a part of the setting, change the setting by the GOT display setting after downloading the
project data.
GT Designer3 (GOT2000) Screen Design Manual
• Screen save time
By using the system information function, the screen save function can forcibly enabled from a controller
(Forced Screen Saver Disable Signal) or the screen saving time set in the utility can be disabled (Automatic
Screen Saver Disable Signal).
GT Designer3 (GOT2000) Screen Design Manual
[GOT Setup] on GT Designer3.
12 DISPLAY AND OPERATION SETTINGS (GOT SET UP)
Reference
Page 105 Display setting functions
Page 110 Setting operation of operation
Page 111 Position correction of the touch panel
(touch panel calibration setting)
Page 113 Setting the utility call keys
Setting range
*1
0 to 60 seconds
(At factory shipment: 5 seconds)
0 to 60 minutes
(At factory shipment: 0 minute)
-
12.1 Display Settings
12
[GOT
105