Royal Alida Air 120 Manual page 45

11 USING THE STOVE
11.1 POWER ON
Before each ignition, make sure that the burn pot is completely empty and correctly positioned in its seat.
To turn on the stove keep the
Automatic ignition: the stove is equipped with an automatic device that allows pellet ignition without the use of
other traditional ignitors.
Avoid manually turning on the stove if the automatic ignition system is compromised.
During initial ignition of the stove it is possible to generate unpleasant smells or fumes caused by the evaporation
or drying of some of the materials used. This phenomenon will gradually disappear.
11.2 MODIFYING THE PARAMETERS
It is possible to change the operating parameters of the stove according to what has already been stated.
supply.
11.3 SWITCHING OFF
To switch it on again, it is advisable to wait for the stove to cool completely.
the power supply.
11.4 OPERATION WITH ROOM THERMOSTAT
When the stove is controlled by an external thermostat (or chronothermostat), the installer must have input
thermostat (closed circuit).
11.5 OPERATION WITH ROOM PROBE ON THE STOVE
The stove modulates the power according to the room temperature detected by the probe on board (i.e. the
stove attempts to maintain the desired temperature by consuming as little fuel as possible).
delta (see par. 10.3).
It is possible to set the desired room temperature in the temperature menu
key pressed for a few seconds.
when the external thermostat is reached (open circuit).
automatically when the temperature falls below the value set on the external
004778400 - 24/07/2020
key), the stove must
.
45