Table of Contents
Advertisement
Setup & Operation 1. Safety
1.2 Design and Installation Safety
Only trained personnel should design and install the robot system. Trained personnel are
defined as those who have taken robot system training and maintenance training classes
held by the manufacturer, dealers, or local representative companies, or those who
understand the manuals thoroughly and have the same knowledge and skill level as those
who have completed the training courses.
To ensure safety, a safeguard must be installed for the robot system. For details on the
safeguard, refer to the Installation and Design Precautions in the Safety chapter of the
EPSON RC+ User's Guide.
The following items are safety precautions for design personnel:
■ Personnel who design and/or construct the robot system with this product must
read the Safety chapter in the EPSON RC+ User's Guide. Designing and/or
constructing the robot system without understanding the safety requirements is
extremely hazardous, and may result in serious bodily injury and/or severe
WARNING
equipment damage to the robot system.
■ The Manipulator and the Controller must be used within the environmental
conditions described in their respective manuals.
designed and manufactured strictly for use in a normal indoor environment.
Using the product in an environment that exceeds the specified environmental
conditions may not only shorten the life of the product but may also cause serious
safety problems.
WARNING
■ The robot system must be used within the installation requirements described in
the manuals. Using the robot system outside of the installation requirements
may not only shorten the life of the product but also cause serious safety
problems.
Further precautions for installation are described in the chapter Setup & Operation 3.
Environment and Installation.
installation procedures before installing the robots and robotic equipment.
4
Please read this chapter carefully to understand safe
This product has been
N6 Rev.2
Advertisement
Table of Contents
