Displaying Software Version; Operating Mode Service - DURKOPP ADLER 610-10 Operating Instructions Manual

Settings via software
Operating Instructions 610-10/630-10 - 01.0 - 01/2021
Fig. 48: Length correction (2)
4. Do the same with all further sewing steps.
5. After the last sewing step tap the END button.
 This closes the length correction, and the operating
mode EDIT ( p. 63) opens.
5.6

Displaying software version

To display the software version:
1. Switch the machine off and on ( p. 20).
 The following appears on the display:
• On the left, the class
• On the right, the firmware
 The machine performs a reference run.
 The controller starts in the operating mode that was active
when it was switched off - MAN or AUTO.
5.7

Operating mode SERVICE

More information on the contents of Service mode can be found
in the  Service Instructions.
81