Test Probe Calibration - Fluke 9102S User Manual

Command Description
Set serial duplex mode:
Set serial duplex mode to full
Set serial duplex mode to half
Set serial linefeed mode:
Set serial linefeed mode to on
Set serial linefeed mode to off
Calibration Menu
Read R0 calibration parameter
Set R0 calibration parameter to n
Read ALPHA calibration parameter
Set ALPHA calibration parameter to n
Read DELTA calibration parameter
Set DELTA calibration parameter
Miscellaneous Other Commands
Read firmware version number
Read structure of all commands
Read ALL operating parameters
Read set-point
Legend: [] Optional command data
Note:

Test Probe Calibration

For optimum accuracy and stability, allow the Product to warm up for 10 minutes after power-up and
then allow adequate stabilization time after reaching the set-point temperature. After completing
operation of the calibrator, allow the well to cool by setting the temperature to 25 °C for one-half hour
before turning off the power.
23
Table 3. Controller Communications Commands (cont.)
Command
Format
du[plex]=f[ull]/
h[alf]
du[plex]=f[ull]
du[plex]=h[alf]
lf[eed]=on/of[f]
lf[eed]=on
lf[eed]=of[f]
r[0]
r[0]=n
al[pha]
al[pha]=n
de[lta]
de[lta]=n
*ver[sion]
h[elp]
all
*sr
{} Returns either information
n Numeric data supplied by user
9 Numeric data returned to user
x Character data returned to user
When DUPLEX is set to FULL and a command is sent to READ, the command is returned followed by
a carriage return and linefeed. Then the value is returned as indicated in the RETURNED column.
Command
Returned
Example
du=f
du=h
lf=on
lf=of
r0: 999.999
r=100.7
al al: 9.99999999
al=0.003865
de
de=1.37 de: 9.99999
*ver ver.9999x,9.99
h list of commands
all list of parameters
*sr 999.999 ohms
Dry-well Calibrator
Test Probe Calibration
Returned Acceptable
Example Values
FULL or HALF
ON or OFF
r0: 100.7
95.0 to 105.0
al: 0.003865
0.002 to 0.006
de: 1.50
0.0–3.0v
ver.9102S,1.10
100.123 ohms