Honda CRF250R 2018 Owner's Manual page 49

Fuel System
3. Connect the quick connect fitting to the fuel
joint (2) until you hear the "click" while
holding the connector housing (4). Lock the
slide retainer (3) by pushing it until you hear
the "click".
If it is hard to connect, put a small amount of
engine oil on the pipe end of the fuel joint.
Injector side:
Fuel pump side:
(3)
(3)
(4)
(2)
(4)
(2) fuel joint
(3) slide retainer
(4) connector housing
4. Make sure the connection is secure and that the
slide retainer is firmly locked into place; check
visually and by pulling the connector housing.
5. Install the setting rubber (5) toward the recess
(6) of the setting rubber to the fuel joint (2).
(2)
(2) fuel joint (6) recess
(5) setting rubber
44
Servicing Your Honda
6. Install the clamp (7) and bolt (8) by aligning
the clamp tab (9) with the groove (10) of the
stay.
Tighten the bolt securely.
(2)
(10)
(7) clamp
(8) bolt
(5)
(6)
(9) (7) (8)
(9) clamp tab
(10) groove
7. Install the fuel quick connect fitting cover (11).
Be sure the rubber cover (1) is properly installed
between the fuel quick connect fitting cover and
fuel pump.
(11)
(1)
(1) rubber cover
(11) fuel quick connect fitting cover
8. Increase the fuel pressure (page 50).
9. Install the fuel tank (page 35).