Unit Installation - Trane AQUA NEW STYLUS CFEB Series Installation Manual

Indoor Unit
1. Select a location to route piping,
wiring and drain pipe.
2. Make a hole in the wall using a key
hole saw or hole-cutting drill
attachment.
The hole should be made at a
slight downward slant to the
outdoor side (Figure 5).
Indoor side
Figure 5
Before cutting, check that no pipes
or studs are directly behind the
place to be cut. Avoid areas where
electrical wiring or conduits are
located.
3. Place the unit on a solid and
level foundation.
4. Tubing, wiring through and drain
pipe of low wall and floor
mounted units can be routed,
rear or right side of unit when
facing front.
Ceiling mounted can be routed
straight downward.
5. Pull air filters upward (Figure 6).
Pull
Pull
Figure 6
UNT-SVN009-EN
UNT-SVN009-EN.p65

Unit Installation

6. Unscrew at the return grille
(Figure 7).
Outdoor side
Figure 7
7. Unscrew at the grille bottom
hinges, pull out the screw, and
unscrew at the side panel front
(Figure 8). Then, push down on
the side panel front and pull up
(Figure 9).
Figure 8
Figure 9
5
0.83"(17.5)
B
0.83"(17.5)
Figure 10
Note: = A 0.49" x 1.575" - 4 SLOT
(Mounting hole) (12.5 mm 40.0 mm)
B
Unit Size
CFEB 04-06 36.2" (914)
CFEB 08 46.1" (1,164)
CFEB 10-12 55.9" (1,414)
CFEB 14 65.7" (1,664)
CFEB 16-20 75.6" (1,914)
8. Place or hang the unit at the
selected position.
9. Replace both right and left side
panels, and the return grille after
the installation of wiring, tubing
and piping is complete.
Outdoor Unit
See the proper installation method
provided in the Installation Manual
for the outdoor unit.
9/9/09, 9:57 AM
A
8.5"(215)
5