Copying Problems; Scanning Problems - Samsung CLX-2160 User Manual

Copying problems

Condition
Copies are too light Use Darkness to darken or lighten the
or too dark. background of the copies.
Smears, lines,
• If defects are on the original, use Darkness
marks, or spots
to lighten the background of your copies.
appears on copies.
• If no defects are on the original, clean the
scan unit. See page 10.3.
Copy image is
• Ensure that the original is face down on the
skewed.
scanner glass.
• Check that the copy paper is loaded
correctly.
Blank copies print Ensure that the original is face down on the
out. scanner glass.
Image rubs off the
• Replace the paper in the tray with paper
copy easily.
from a new package.
• In high humidity areas, do not leave paper
in the machine for extended periods of
time.
Frequent copy
• Fan the stack of paper, then turn it over in
paper jams occur.
the tray. Replace the paper in the tray with
a fresh supply. Check/adjust the paper
guides, if necessary.
• Ensure that the paper is the proper paper
weight. 75 g/m2 (20 lb bond) paper is
recommended.
• Check for copy paper or pieces of copy
paper remaining in the machine after a
paper jam has been cleared.
Toner cartridge
• Your originals may contain pictures, solids,
produces fewer
or heavy lines. For example, your originals
copies than
may be forms, newsletters, books, or other
expected before
documents that use more toner.
running out of
• The machine may be turned on and off
toner.
frequently.
• The scanner lid may be left open while
copies are being made.
Suggested solutions

Scanning problems

Condition
The scanner does
not work.
The unit scans
very slowly.
Message appears
on your computer
screen:
• "Device can't be
set to the H/W
mode you want."
• "Port is being
used by another
program."
• "Port is
Disabled.
• "Scanner is busy
receiving or
printing data.
When the
current job is
completed, try
again."
• "Invalid handle."
• "Scanning has
failed."
11.10
<Troubleshooting>
Suggested solutions
• Make sure that you place the original to be
scanned face down on the scanner glass.
• There may not be enough available memory
to hold the document you want to scan. Try
the prescan function to see if that works. Try
lowering the scan resolution rate.
• Check that the USB cable is connected
properly.
• Make sure that the USB cable is not
defective. Switch the cable with a known
good cable. If necessary, replace the cable.
• Check that the scanner is configured
correctly. Check scan setting in the
SmarThru Configuration or the application
you want to use to make certain that the
scanner job is being sent to the correct port.
• Check if the machine is printing received
data. If so, scan the document after the
received data has been printed.
• Graphics are scanned more slowly than text.
• Communication speed slows in scan mode
because of the large amount of memory
required to analyze and reproduce the
scanned image. Set your computer to the
ECP printer mode through BIOS setting. It
will help to increase the speed. For details
about how to set BIOS, refer to your
computer user's guide.
• There may be a copying or printing job in
progress. When that job is complete, try your
job again.
• The Selected port is currently being used.
Restart your computer and try again.
• The printer cable may be improperly
connected or the power may be off.
• The scanner driver is not installed or the
operating environment is not set up properly.
• Ensure that the machine is properly
connected and the power is on, Then restart
your computer.
• The USB cable may be improperly
connected or the power may be off.