Advertisement
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com
2.0 Unpacking, Shipping and Installation
2.1 Unpacking
2.2 Shipping
2.3 Installation
!
Install unit carefully! Improper installation voids warranty.
The PICO-155S should be placed on a flat stable surface.
Connect the micrometer by pushing the micrometer flush then snugly tighten the locking bolt.
CAUTION: DO NOT over tighten as this may damage the micrometer.
Then position the specimen arm and loading bar to the micrometer
shaft so they are both at about the same angle to the shaft.
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
PICO-155S Precision Saw
Unit is delivered in a box. Unpack and check for
completeness of parts.
Crate Measures WxHxD: 24" x 36" x 23"
Crate Weight:
When moving cutter, lift by the base.
The PICO-155S is constructed with sensitive
electronic and mechanical components.
DO NOT DROP.
!
Caution:
Take care to avoid bodily injury.
(Installation continued on next page)
I
NSTRUCTION
Web: http://www.metallographic.com
Approximately 105 lbs
M
ANUAL
5
Advertisement
