Advertisement
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com
5.0 Maintenance
5.1
Introduction
The PICO-155S wafering saw requires very minimal maintenance. However, to increase the
life of the saw, it is suggested that the cutting fluid be changed regularly (weekly) using a
cutting fluid containing an anti-corrosion additive (e.g DIACUT 2 cutting fluid).
After use it is also recommended that the unit be thoroughly rinsed and dried.
DIACUT oil-
based cutting
fluid
Periodically remove the micrometer shaft and clean any cutting swarf material build up on the shaft.
Remove micrometer
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
PICO-155S Precision Saw
DIACUT 2 anti-
corrosion cutting fluid
I
NSTRUCTION
Web: http://www.metallographic.com
Remove and clean
coolant tank- replace
with recommended
cutting fluid
Remove micrometer
Shaft and clean
M
ANUAL
21
17
Advertisement
